Configure SNMP settings

From Policy Catalog → Common Appliance Management → General → <policy name> → SNMP, configure SNMP Alerts:

1. Enable SNMP alerts.

2. Enter the address or host name for your Trap destination.

3. Enter the Community name you have set up for your SNMP management system.

4. Select the required version of the SNMP protocol to use.

5. (Optional) Click the + icon and repeat steps b through d to add more than one trap destination.

Configure SNMP Monitor:

1. Enable SNMP monitor.

2. Select the version of the SNMP protocol used by your SNMP management system.

For SNMP versions v1 or v2c:

1. Enter the community name you have set up for your SNMP management system.

For SNMP version v3:

1. Enter the user name that you have configured for your SNMP management system.

2. Enter your required authentication protocol. This can be either MD5 Protocol or SHA Protocol.

3. Enter your required privacy protocol. This can be either DES Protocol or AES Protocol.

4. Enter the authentication passphrase.

5. Enter the privacy passphrase.

Select either Allow SNMP monitor for all hosts, or Allow SNMP monitor for these hosts only.

If you selected Allow SNMP monitor for these hosts only, you must configure at least one host before you can save the SNMP settings.

Click Save to save these changes, or Duplicate to create a policy using these settings.