Use the default IP addresses rather than assigning dynamic IP addresses to configure each appliance.
LAN 1 — 10.1.1.108/24
You can use LAN 1 for management traffic.
OOB — 10.1.3.108/24
(Optional) Use the Out-of-band (OOB) network for management traffic including ePO - SaaS communication.
Capture port 1 — Use the Capture port 1 port as a packet capture interface. Capture port 1 does not require an IP address. It must be connected to your network to acquire packets for analysis. Typically, it is connected to a SPAN port or network tap.
Note
If your network uses DHCP, the first IP address that the DHCP server assigns to the appliance is used instead. You can manually configure the IP address from the Setup Wizard. The appliance doesn't support using a continuous DHCP configuration.
The default gateway for the appliance uses the LAN 1 network. Configure any routing required on the OOB interface using static routes.