To load balance the analysis of incoming traffic, you can set up a cluster of Trellix DLP Network Monitor – SaaS appliances.
Configure the Trellix DLP Network Monitor – SaaS appliance for a cluster role from the Setup Wizard during installation.
Configure two or more Trellix DLP Network Monitor – SaaS appliances with LAN 1 connected to the same network segment.
All appliances in a cluster must be in the same subnet or network.
In ePO - SaaS, open the Policy Catalog.
Select the DLP Appliance Management <version> product, choose the General category, and open the policy that you want to edit.
In Load Balancing, select Enable.
In Cluster ID, use the arrows to select a number to identify the cluster.
In Virtual IP, enter a virtual IP address so that packets for the virtual IP address are sent to the cluster primary.
The appliances in the cluster use the netmask assigned to the physical IP address. The virtual IP address must be in the same subnet or network as the other Trellix DLP Network Monitor – SaaS appliances, and cannot be the same IP address as any other appliance in the cluster.
Caution
The cluster ID and virtual IP address must be same for all members of a cluster.
Click Save.
ePO - SaaS pushes the configuration to all appliances in the cluster when you apply the changes. It takes about five minutes for the cluster to stabilize and identify the cluster primary and cluster scanners. The appliance descriptions then change accordingly in Appliance Management.