Configure Case sensitivity on standalone Solidcore Client

Follow these steps to enable case sensitivity support on standalone Solidcore Client.

1. Recover CLI.

2. Disable Solidcore and reboot the system if Solidcore is in enable mode.

3. Once the system is up and running, run this command at the command prompt to enable inventory case-sensitivity:

   sadmin config set InventoryCaseSensitivityEnabled=1

   For information about "InventoryCaseSensitivityEnabled" values, see KB96798.

4. Clean inventory using command:

   sadmin clean C:\

5. Resolidify the system and enable Solidcore.

Follow these steps to disable case sensitivity support on standalone Solidcore Client.

1. Recover CLI.

2. Disable Solidcore and reboot the system if Solidcore is in enable mode.

3. Once the system is up and running, run the command applicable to your operating system to disable inventory case-sensitivity:

   • Windows 10: sadmin config set InventoryCaseSensitivityEnabled=0

   • Windows 11: sadmin config set InventoryCaseSensitivityEnabled=2

4. Clean inventory using command:

   sadmin clean C:\

5. Resolidify the system and enable Solidcore.