Enable and configure Firewall on a client system

You can configure settings for Firewall to turn firewall protection on and off, enable Adaptive mode, and configure other Firewall options.

Before you begin

Make sure that the interface mode for the Trellix Endpoint Security (ENS) Client is set to Full access or log on to the Trellix Endpoint Security (ENS) Client as administrator.

Task

Open the Trellix Endpoint Security (ENS) Client.
Click Firewall on the main Status page.
Or, from the Actionmenu , select Settings, then click Firewall on the Settings page.
Select Enable Firewall to make the firewall active and change its options.
Note
Host Intrusion Prevention 8.0 can be installed on the same system as Trellix ENS version 10.7. If McAfee Host IPS Firewall is installed and enabled, Trellix ENS Firewall is disabled even if enabled in the settings.
Click Show Advanced.
Configure settings on the page, then click Apply.