Sets the default server type for the upload destination service on an appliance.
Note
This is one of a series of commands used to configure DTI service settings. See your System Administration Guide or Administration Guide for details.
Syntax
fenet dti upload destination default <type>
no fenet dti upload destination type
Parameters
no
Use the no form of the command to restore the default server type. The default server type for standalone appliances and the Central Management System appliance is DTI. The default server type for managed appliances is CMS.
type
DTI—Trellix Dynamic Threat Intelligence server.CMS—The Central Management System appliance. Available to managed appliances only.CUSTOM—A custom DTI server, if configured. Used in a Network Address Translation (NAT) deployment in which a managed appliance uses the dual-port address type to communicate with the Central Management System appliance, and the Central Management System appliance is in an internal network that the managed appliance cannot reach.
Example
The following command changes the default setting for the upload destination to DTI.
hostname (config) # fenet dti upload destination default DTI
User role
Admin or Operator
Command mode
Config
Supported appliances
This command is supported on the following appliances running the specified releases or later:
Malware Analysis: Release 8.3.0
Email Security — Server: Release 8.2.0
File Protect: Release 9.0.0
Network Security: Release 8.3.0
Intelligent Virtual Execution - Server: Release 8.3.0