To specify which subdirectory a configured scan should check, use the fmps scan configure subdirectories command in configuration mode.
Note
You can use this command only on scans that are in the "configured" state. You cannot configure active, paused, aborted, completed, or scheduled scans.
This command allows you to limit the scope of a scan by specifying that it should check only the specified subdirectory.
For more information, see the File Protect User Guide.
Syntax
[no] fmps scan configure<scanID>subdirectories<subdirectory>
Parameters
no
Removes the configured subdirectory.
scanID
The numeric identifier for the scan.
subdirectories
The subdirectory to scan.
Example
The following example specifies that scan 2 should check only the Hardware subdirectory.
hostname (configure) # fmps scan configure 2 subdirectories Hardware
User role
Operator or Admin role
Supported appliances
Command introduced in Release 7.5.0 for File Protect appliances.