Re-enable relay mode after upgrading the server

If the Endpoint Security (HX) server is in relay mode when it is upgraded, reenable relay mode after the upgrade.

Log in to the Endpoint Security (HX) server as an administrator.
Go to CLI configuration mode on the Endpoint Security (HX) server.
hostname > enable
hostname > #configure terminal
Review your relay mode settings before proceeding.
hostname (config) # show hx rproxy
Reenable relay mode.
hostname (config) hx rproxy relay <hostname-or-IPaddress>
where <hostname-or-IPaddress> is the host name or IP address of the Endpoint Security (HX).
Save your settings.
hostname (config) # write memory