Displays the configuration of the network whitelist.
Syntax
show policymgr networks
Parameters
None
Output fields
The following table describes the output fields for the show policymgr networks command. Fields are listed in the approximate order in which they appear in the output.
Field | Description |
|---|---|
Whitelist Entries | Number of network entries on the whitelist. You can add up to 256 network whitelist entries. |
VLAN | VLAN identification number on the network whitelist. The default value is "ALL". The range is from 1 to 4094. |
INTF | Interface that is added to the network whitelist. When you apply interface A, traffic entering the Network Security appliance on pether3 and pether4 is whitelisted. When you apply interface B, traffic entering the Network Security appliance on pether5 and pether6 is whitelisted. The following interfaces are available:
|
Monitor | Whether traffic is monitored and allowed from the specified host, network, or VLAN. |
IP | IP address that matches the defined IP address or mask. |
MODE(source|destination|host) | The mode that is configured for a network whtielist. |
Example
The following example displays the configuration of a whitelist.
hostname (config) # show policymgr networks Whitelist Entries: 3 / 256 Whitelist: VLAN INTF MONITOR IP MODE(source|destination|host) ALL ALL no 1.1.1.1/32 host ALL ALL n/a 23.1.1.1/32 src ALL ALL n/a 23.1.1.2/32 dst
User role
Administrator, Monitor, or Analyst
Command mode
Enable
Supported appliances
This command is supported on the following appliances running the specified releases or later:
Network Security: Release 8.0. The command output was enhanced to include a total of 256 rule entries in Release 8.0.