Adds a range of IP addresses to the data exfiltration home network (homenet) list on a SmartVision appliance on which data exfiltration detection is enabled.
SmartVision appliances are described in the Network Security SmartVision Feature Guide.
The data exfiltration homenet list specifies the network hosts that the SmartVision appliance monitors for data theft activity. If the homenet list is empty, the appliance cannot detect data exfiltration. The data exfiltration homenet list is empty by default.
Note
You can also run this command remotely from the command line of an integrated Trellix Central Management System appliance using the central management appliance proxying mechanism.
Syntax
[no] smartvision exfil homenet <ip address>/<prefix>
Parameters
no
Use the no form of the command to remove the specified range of IP address from the data exfiltration homenet list.
<ipAddress>
The IPv4 or IPv6 address of the post-exploitation threat activity receiver or sender.
<prefix>
The length of the IP address subnet mask.
Example
hostname (config) # smartvision exfil homenet 2001:db8:701f::/48
Command mode
Config
Supported appliances
This command is supported on the following appliances running the specified releases or later:
Network Security: Release 8.0.