Configuring DTI credentials using the CLI
- Published on Aug 25, 2026
Use the commands in this topic to configure DTI credentials (username and password).
To configure DTI credentials:
Go to CLI configuration mode:
hostname > enable
hostname # configure terminal
Specify the user and password:
hostname (config) # fenet dti source type <name> username <user> password <password>
The variables have the following values:
Verify your changes:
hostname (config) # show fenet dti configuration
Save your changes.
hostname (config) # write memory
Was this article helpful?
Related articles
File Protect (FX) > File Protect 11.x > File Protect 11.x System Administration Guide > Configuration > The DTI network > Configuring DTI credentials
File Protect (FX) > File Protect 10.x > File Protect System Administration Guide Release 10.x > Configuration > The DTI network > Configuring DTI credentials
Malware Analysis (AX) > Malware Analysis System Administration Guide Release 10.x > Configuration > The DTI network > Configuring DTI credentials