Configuring scan results folders using the CLI

Use the commands in this section to configure scan results folders using the CLI.

Note

You can use these commands only on scans that are in the "configured" state. You cannot configure active, paused, aborted, completed, or scheduled scans.

To configure scan results folders:

Enable the CLI configuration mode:

hostname > enable
hostname # configure terminal

Verify the status of the share to which you want to map the folder:
```
hostname (config) # show fmps file shares shareName
```

Specify the results folder:

To configure a folder for non-malicious files:

hostname (config) # fmps scan configure scanID target-shares good shareName

To configure a folder for malicious files:

hostname (config) # fmps scan configure scanID target-shares quarantine shareName

To configure a folder for unknown files:

hostname (config) # fmps scan configure scanID target-shares unknown shareName

To configure a folder for whitelist files:

hostname (config) # fmps scan configure scanID target-shares whitelisted shareName

Save your changes:
```
hostname (config) # write memory
```

Example

The following example shows how to check the status of the Acme-good share and then configure a "good" folder for scan 37.

hostname (config) # show fmps file shares Acme-good
Share Name:   Acme-good
Enabled:      yes
Description:  ********
Share URL:    //10.14.40.30/IX-good
Mount command prefix:     mount --no-mtab -t cifs -o sec=ntlmsspi
Share user:  fmps-dfs\Administrator
Share password:    ********
hostname (config) # fmps scan configure 37 target-shares good Acme-good