Use the commands in this section to enroll a standalone sensor with an IVX cluster.
To enroll a standalone sensor:
Log in to the sensor CLI.
Go to CLI configuration mode:
sensor-hostname > enable sensor-hostname # configure terminal
Configure the enrollment service address (the IP address of the Central Management appliance that manages the cluster):
sensor-hostname (config) # fenet dti enrollment service type DTI address <cluster CM address>where <
cluster CM address> is the IP address of the Central Management appliance that manages the IVX cluster.Verify your changes:
sensor-hostname (config) # show fenet dti configurationVerify the enrollment service settings:
sensor-hostname (config) # show mvx cluster enrollment serviceSave your changes:
sensor-hostname (config) # write memory
Example
In this example, the standalone nx-5 sensor is enrolled with a cluster that is managed by a Central Management appliance with an IP address of 10.11.10.11.
nx-5 (config) # fenet dti enrollment service type DTI address 10.11.10.11 nx-5 (config) # show fenet dti configuration DTI CLIENT CONFIGURATIONS: ACTIVE SETTINGS: Mode : online Download source : DTI (User8@cloud.fireeye.com) Upload destination : DTI (User8@up-cloud.fireeye.com) Mil service : DTI (User8@up-cloud.fireeye.com) Enrollment service : DTI (User8@10.11.10.11) ... nx-5 (config) # show mvx cluster enrollment status MVX Cluster Enrollment Status Enrollment Client : Status ok : yes Status description : enrolled Last checked at : 2019/08/14 14:56:01 Enrollment Service : Auto enabled : yes Service address : DTI (10.11.10.11) Preferred cluster : any (less loaded) Cloud enabled : no Cloud License enabled : no Connect on demand : no Broker Info : Cluster Name : Cluster-02 Broker Name : vx-4 Broker Address : 10.11.12.13 Broker ID : 002XXXXXXXXX Broker State : Connected Failure Reason : None Last Connection Attempt: 2019/08/12 15:01:11 Connection Last Formed : 2019/08 Connection Last Broken :