Use the commands in this topic to manually mount or unmount a USB device to the attached appliance. Trellix recommends that you physically remove the USB device from the port. Use the media usb mount command before you attach the drive, and use the media usb eject command after you unplug it.
Note
The media usb eject command will have no effect if the USB device is not mounted.
Prerequisites
Admin access
To mount a USB device:
Go to CLI configuration mode:
hostname > enable
hostname # configure terminal
Mount the USB device to the attached appliance:
hostname (config) # media usb mount
To unmount a USB device:
Go to CLI configuration mode:
hostname > enable
hostname # configure terminal
Unmount the USB device from the attached appliance:
Malware Analysis (AX) > Malware Analysis System Administration Guide Release 10.x > Administration > Upgrading the Trellix software > Configuring auto-mounting on a USB device
Malware Analysis (AX) > Malware Analysis System Administration Guide Release 11.x > Administration > Upgrading the Trellix software > Configuring auto-mounting on a USB device