Restoring limits to default values for automatic artifact cleanup using the CLI
You can restore all artifact cleanup limits to their defaults with a single CLI command.
To restore artifact cleanup limits to the defaults:
Go to CLI configuration mode:
hostname > enable
hostname # configure terminal
To set artifact cleanup limits to the defaults:
hostname (config) # analysis artifacts-cleanup set-default
Save your changes.
hostname (config) # write memory
Was this article helpful?
Related articles
Malware Analysis (AX) > Malware Analysis System Administration Guide Release 10.x > Administration > Disk space management > Deleting files automatically
File Protect (FX) > File Protect 11.x > File Protect 11.x System Administration Guide > Administration > Disk space management > Deleting files automatically
Malware Analysis (AX) > Malware Analysis System Administration Guide Release 11.x > Administration > Disk space management > Deleting files automatically