Viewing HA interface status using the CLI

Use the commands in this section to view the status of the HA interfaces.

Note

This procedure shows the status on one node at a time. To view the status for both nodes at the same time, use the show ha status command, described in Viewing the cluster status using the CLI.

To view the HA interface status:

Log in to either node.
Enable the CLI enable mode:
```
node-hostname > enable
```
View the status of the node's interfaces:
```
node-hostname # show ha interfaces
```
Repeat these steps on the other node to view the status of its interfaces.

For a description of the interface states, see Viewing the cluster status.

Example

The following example shows the status of the HA interfaces on node1 in a dual-interface configuration.

node1 # show ha interfaces
 Interfaces
default: up
backup: up