Follow these steps to view the number of active rules that are shared between local and remote Central Management System peers for Central Management System Peer Signature Sharing using the CLI.
Note
When the DTI feature is enabled, there will be a slight discrepancy in the Active rules value in the show localsig command output. This discrepancy is due to the way data is aggregated and synchronized.
To view the number of active rules for Central Management System Peer Signature Sharing:
Go to CLI enable mode.
CMS1 > enable
Verify the number of active rules that are shared between Central Management System peers.
Central Management System (CMS) > Central Management System System Administration Guide Release 10.x > Appendices > Configuring the CM peer service > Central Management System Peer Distributed Correlation
Central Management System (CMS) > Central Management System System Administration Guide Release 10.x > Appendices > Configuring the CM peer service > Enabling or disabling all the features of the Central Management System Peer Service on the peers