Read and follow these safety warnings when you install the Intelligent Sandbox Appliance.
Caution
Failure to observe these safety warnings could result in serious physical injury.
Power Supply
The push-button on/off power switch on the front panel of the Intelligent Sandbox Appliance does not turn off the AC power. To remove AC power from the Intelligent Sandbox Appliance, you must unplug the AC power cord from either the power supply or wall outlet for both the power supplies.
If you press the push-button on/off power switch on the front panel of the Intelligent Sandbox Appliance while the appliance is running, it shuts down. If you want to power off the appliance, use CLI command — shutdown, then after the system halts—press the power button until the appliance turns off.
The power supplies in your system might produce high voltages and energy hazards, which can cause bodily harm. Only trained service technicians are authorized to remove the covers and access any of the components inside the system.
Hazardous electrical conditions might be present on power, telephone, and communication cables. Turn off the Intelligent Sandbox Appliance and disconnect telecommunications systems, networks, modems, and both the power cords attached to the Intelligent Sandbox Appliance before opening it. Otherwise, personal injury or equipment damage can result.
This equipment is intended to be grounded. Ensure that the host is connected to earth ground during normal use.
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables.
Avoid Injuries
Lifting the Intelligent Sandbox Appliance and attaching it to the rack is a two-person job.
Appliance outer shell
Do not remove the outer shell of the Intelligent Sandbox Appliance. Doing so invalidates your warranty.
Do not operate the system unless all cards, faceplates, front covers, and rear covers are in place. The faceplates and cover panels prevent exposure to hazardous voltages and currents inside the chassis. The components might produce high electromagnetic interference (EMI) that might disrupt other nearby equipment.
Ensure that the appliance is placed in such a manner that flow of cooling air through the chassis is not blocked.