boot next fallback-reboot enable

Use this command to enable or disable the fallback reboot during upgrade or downgrade activities.

By default, if the appliance fails to apply the configuration during a software upgrade or downgrade action, the appliance will reboot using the backup partition. You can use the no variant of this command to disable this action.

Note

The fallback reboot is always triggered if you are downgrading to an older software version that has never been run on the appliance before. You can suppress this behavior by using the no boot next fallback-reboot enable command.

Syntax

[no] boot next fallback-reboot enable

Parameters

no

Disables the reboot fallback behavior on the appliance.

Example

The following example enables the fallback behavior. (default behavior)

hostname (config) # boot next fallback-reboot enable

The following example disables the fallback behavior.

hostname (config) # no boot next fallback-reboot enable

User role

Admin

Command mode

Config

Supported Appliances