To enable HTTP access on the loopback interface on the appliance, use the media usb web-access enable local command in configuration mode. The no form of this command disables HTTP access on the loopback interface.
This command specifies whether a mounted USB device is used for HTTP access on the loopback interface. Local web access is enabled by default. Use the media usb web-access top-dir command to configure the top-level directory for HTTP access.
Syntax
[no] media usb web-access enable local
User role
Admin
Parameters
None
Example
The following example enables HTTP access on the loopback interface:
hostname (config) # media usb web-access enable local
Supported appliances
Command was introduced before Release 7.5.0.