Enables or disables a RADIUS server on the specified port. A RADIUS server is enabled by default after it is added to the appliance configuration. You can also use the no form of this command to add a RADIUS server that is initially disabled.
Syntax
[no] radius-server host <ip address> auth-port <port number> enable
Parameters
no
Use the no form of this command to disable a RADIUS server or add a new RADIUS server that is initially disabled.
ip address
Specify the IPv4 or IPv6 address of the RADIUS server.
port number
Specify the UDP port number. The default is 1812. Valid values are 1–65535.
Example
The following example disables the specified RADIUS server.
hostname (config) # no radius-server host 192.168.1.1 auth-port 1645 enable
User Role
Admin
Command mode
Config
Supported appliances
This command is supported on the following appliances running the specified releases or later:
Malware Analysis: Before release 6.4. Support for IPv6 addresses was added in Release 8.2.
Central Management System: Before release 6.4. Support for IPv6 addresses was added in Release 8.3.
Email Security — Server: Before release 6.4. Support for IPv6 addresses was added in Release 8.2.
File Protect: Before Release 6.4. Support for IPv6 addresses was added in Release 8.2.
Endpoint Security (HX): Release 2.5
Network Security: Before release 6.4. Support for IPv6 addresses was added in Release 8.2.
Intelligent Virtual Execution - Server: Release 7.9. Support for IPv6 addresses was added in Release 8.2.