Enables or disables a RADIUS server. A RADIUS server is enabled by default after it is added to the appliance configuration. You can also use the no form of this command to add a RADIUS server that is initially disabled.
Syntax
[no] radius-server host <ip address> enable
Parameters
no
Use the no form of this command to disable a RADIUS server in the appliance configuration, or add a new RADIUS server that is initially disabled.
ip address
Specify the IPv4 or IPv6 address of the RADIUS server.
Example
The following example disables the specified RADIUS server.
hostname (config) # no radius-server host fdd3:c75:345::8a4 enable
User role
Admin
Command mode
Config
Supported appliances
This command is supported on the following appliances running the specified releases or later:
Malware Analysis: Before release 6.4. Support for IPv6 addresses was added in Release 8.2.
Central Management System: Before release 6.4. Support for IPv6 addresses was added in Release 8.3.
Email Security — Server: Before release 6.4. Support for IPv6 addresses was added in Release 8.2.
File Protect: Before Release 6.4. Support for IPv6 addresses was added in Release 8.2.
Endpoint Security (HX): Release 2.5
Network Security: Before release 6.4. Support for IPv6 addresses was added in Release 8.2.
Intelligent Virtual Execution - Server: Release 7.9. Support for IPv6 addresses was added in Release 8.2.