Displays the status and traffic statistics for one or all interfaces. You can also view a brief summary of the status information (no traffic statistics) or just the interface configuration.
Note
Monitoring (pether3 to pether_n) ports are not displayed using the show interfaces command. To see the status of these ports, use the show interfaces name command.
Syntax
show interfaces [name] [brief | configured]
Parameters
name | Interface name (such as “ether1,” “tap0,” or “lo” for loopback). |
brief | Displays a brief summary of the status information (no traffic statistics). |
configured | Displays just the configured settings for the enabled interfaces. |
Examples
The following example shows status and traffic statistics for all interfaces.
hostname # show interfaces
Interface ether1 state Admin up: yes Link up: yes IP address: 192.168.0.69 Netmask: 255.255.255.0 Speed: 1000Mb/s (auto) Duplex: full (auto) Interface type: ethernet MTU: 1500 HW address: 00:0C:29:5D:D7:28
RX bytes: 11668267 RX packets: 107222RX mcast packets: 0 RX discards: 0 RX errors: 0 RX overruns: 0 RX frame: 0
TX bytes: 4458023 TX packets: 13155 TX discards: 0 TX errors: 0 TX overruns: 0 TX carrier: 0 TX collisions: 0
Interface ether2 state Admin up: yes Link up: yes
The following example shows status and traffic statistics for the pether3 interface.
hostname # show interfaces pether3
Supported appliances
This command was released as follows:
Endpoint Security (HX): Release 2.5