When the supported appliance is operating in layer 3 mode, this command displays the status and traffic statistics for the specified monitoring port.
Note
The following Network Security virtual appliances support layer 3 mode: NX 2500V, NX 2501V, NX 2550V, NX 4500V, and NX 6500V.
You can also view a brief summary of the status information (no traffic statistics) or just the interface configuration.
Syntax
show interfaces <portName> [brief | configured]
Parameters
<portName>
The monitoring port, such as pether3, for which the status and traffic statistics are to be dfisplayed.
brief
(Optional) Displays a brief summary of the status information (no traffic statistics).
configured
(Optional) Displays just the configured settings for the enabled interfaces.
Examples
The following commands show that pether3 and pether4 are mapped to network namespace vrfA. In this example, static routes have not yet been configured for vrfA.
hostname (config) # show interfaces pether3 brief Interface pether3 status: Comment: Admin up: yes Link up: yes DHCP running: no IP address: Netmask: IPv6 enabled: no Speed: 10000Mb/s Duplex: full Interface type: ether Interface ifindex: 23 Interface source: physical Interface namespace:vrfA MTU: 1600 HW address: 00:50:56:01:2F:A1
hostname (config) # show interfaces pether4 brief Interface pether4 status: Comment: Admin up: yes Link up: yes DHCP running: no IP address: Netmask: IPv6 enabled: no Speed: 10000Mb/s Duplex: full Interface type: ether Interface ifindex: 24 Interface source: physical Interface namespace:vrfA MTU: 1600 HW address: 00:50:56:01:2F:A2
Supported appliances
This command is supported on the following appliance running the specified release or later:
Network Security: Release 9.0