Displays the authentication status and keys for active NTP servers and peers.
Syntax
show ntp authentication
Parameters
None
Output fields
The following table describes the output fields for this command.
Field | Description |
|---|---|
Address | The IP address of the NTP server. (This command displays the IP address of the NTP server, even if you configured it with the hostname.) |
reachable | Whether the appliance can reach the NTP server. |
auth | The authentication status: ok—The authentication succeeded. bad—An authentication key is configured, but the authentication failed. none—No authentication key is mapped to the NTP server. n/a—An authentication key is configured, but the server not reachable yet. |
keyid | The integer from 1—16 that identifies the authentication key. |
Example
The following example shows that the appliance can reach all three NTP servers. Authentication keys are configured for the first two servers, and the authentication succeeded. No authentication key is mapped to the third server.
hostname > show ntp authentication NTP is administratively enabled. NTP authentication is administratively enabled. Active servers and peers: Address reachable auth keyid ============================================ 172.16.2.3 yes ok 2 10.30.4.3 yes ok 15 192.168.10.12 yes none none
User role
Admin, Operator, Monitor
Command mode
Enable
Supported appliances
This command is supported on the following appliances running the specified releases or later:
Email Security — Server: Release 7.8.0
Endpoint Security (HX): Release 2.5