show ntp configured

Displays the current NTP status, and the configured NTP servers and their settings.

Syntax

show ntp configured

Parameters

None

Output fields

The following table describes the output fields for this command.

Field	Description
NTP enabled	Whether NTP is enabled on the appliance.
NTP Authentication enabled	Whether NTP authentication is enabled on the appliance.
No NTP peers configured	Indicates that no NTP peers are configured on the appliance.
NTP server	Information about the NTP server: IP address or hostname—The IP address or hostname that was used to configure the NTP server on the appliance. Enabled—Whether NTP is currently enabled on the NTP server. NTP version—The NTP version (3 or 4) running on the NTP server. Key—An integer from 1—16 that identifies the authentication key mapped to the server. If no key is mapped, none is displayed.

Example

The following example shows the current NTP status and NTP server information.

hostname > show ntp configured
NTP enabled: yes
NTP Authentication enabled: yes
No NTP peers configured.
NTP server 0.acme.pool.ntp.org
  Enabled: yes
  NTP version: 4
  Key: 10
NTP server 1.acme.pool.ntp.org
  Enabled: yes
  NTP version: 4
  Key: 12
NTP server 2.acme.pool.ntp.org
  Enabled: no
  NTP version: 4
  Key: none

User role

Admin, Operator, or Monitor

Command mode

Enable

Supported appliances

This command is supported on the following appliances running the specified releases or later:

Malware Analysis: Before release 6.4
Central Management System: Before release 6.4
Email Security — Server :Before release 6.4. The NTP Authentication and Key output lines were introduced in EX Series Release 7.8.0.
File Protect: Before release 6.4
Endpoint Security (HX): Release 2.5
Network Security: Before release 6.4