The Intelligent Sandbox Appliance has redundant power supplies pre-installed.
The Intelligent Sandbox Appliance ships with two AC power cords specific to your country or region.
Plug one end of the AC power cord into the first power supply module in the back panel, then plug the other end into the power source.
Plug one end of the other AC power cord into the second power supply module in the back panel, then plug the other end into the power source.
Intelligent Sandbox powers up without pressing the on/off button on the front panel.
To turn off the Intelligent Sandbox Appliance AC power, you must unplug both AC power cords from the back panel or power source.
Note
The on/off button on the front panel does not turn on/off the AC power.
To restart the Intelligent Sandbox Appliance, you must press the on/off power switch on the front panel while the appliance is turned on.
To turn off the Intelligent Sandbox Appliance, use the shutdown CLI command, then press the on/off power switch.
Note
When you plug power cord to both PSUs on ATD 3200/ATD 6200 model and provide power to both PSUs, you will see one PSU LED is blinking in 1 Hz frequency in green.
This is an expected behavior. The power supply with the blinking LED is in cold redundant state, meaning it is powered down to standby mode until the other power supply fails, or until the power supplies switch roles between primary and standby.