Viewing resource agent status using the CLI

Use the commands in this section to view the current status of resource agents on both nodes.

To view resource agent status:

Log in to either node.
Enable the CLI enable mode:
```
node-hostname > enable
```
View the resource agent status:
```
node-hostname # show ha resources
```

For a description of the resource agent states, see Viewing resource agent status .

Example

The following example shows the resource agent status from the primary node.

node1 # show ha resources
Resource Status
                                node1      node2
  Resources
  Resources 15
         sys_disk_monitor:      running    running
         sys_ether1_monitor:    running    running
         fe_address:            off        off
         fe_correlator:         running    off
         fe_cmsapi:             running    off
         fe_dbmgd:              running    off
	  fe_vsmon:              running    off
         fe_aggregator:         running    off
         fe_aggr:               running    off
         fe_fedb:               running    running
         fe_webui:              running    off
         fe_redis:              running    off
         fe_peer_service:       running    off
         fe_notification:       running    off
         fe_http:               running    running
         fe_appmgrd:            running    off