Use this command to reset the data path port speed on an appliance.
Syntax
fe-fastpath set port <port-name> speed <port-speed>
Parameters
port-name
The port name for which to set the speed. The port names available depend on the number of ports on your appliance. For example, an NX 4500 appliance has port names from pether3 to pether14.
port-speed
The Ethernet port speed.
The speed for a 1 GB port can be set to one of the following:
10_half10_full100_half100_full1000_fullauto
The speed for a 10 GB port can be set to one of the following:
10000_full1000_fullauto
Example
The following example resets the interface speed for port pether4 to 10 Mbps, half-duplex:
hostname (config) # fe-fastpath set port pether4 speed 10_half
User Role
Admin
Command Mode
Config
Supported Appliances
This command is supported on the following appliances running the specified releases or later:
Network Security: Release 8.2