Specifies a global value for the number of times an appliance will retransmit a request to authenticate with a RADIUS server configured on an appliance before the request fails. The default is 1. If you specify 0, no retransmit attempts will be made. This number applies to all new RADIUS servers configured on an appliance and becomes the new default value.
Note
This number is not used for a specific RADIUS server if another number is configured using the
radius-server host <ip address> retransmit <retries>command.
Syntax
[no] radius-server retransmit <retries>
Parameters
no
Use the no form of this command to reset the default value.
retries
Specify the number of retry attempts. Valid values are 0–5. The default is 1.
Examples
The following example specifies that authentication requests should be retried three times before failing.
hostname (config) # radius-server retransmit 3
The following example resets the default retransmit value (1).
hostname (config) # no radius-server retransmit
User role
Admin
Command mode
Config
Supported appliances
This command is supported on the following appliances running the specified releases or later:
Malware Analysis: Before release 6.4. Support for IPv6 addresses was added in Release 8.2.
Central Management System: Before release 6.4. Support for IPv6 addresses was added in Release 8.3.
Email Security — Server: Before release 6.4. Support for IPv6 addresses was added in Release 8.2.
File Protect: Before Release 6.4. Support for IPv6 addresses was added in Release 8.2.
Endpoint Security (HX): Release 2.5
Network Security: Before release 6.4. Support for IPv6 addresses was added in Release 8.2.
Intelligent Virtual Execution - Server: Release 7.9. Support for IPv6 addresses was added in Release 8.2.