Specifies a global value for the number of seconds before retransmitting a request that previously failed to a RADIUS server configured on an appliance. This number applies to all new RADIUS servers configured on an appliance and becomes the new default value.
Note
This number not used for a specific RADIUS server if another number is configured using the
radius-server host <ip address> timeout <seconds>command.
Syntax
[no] radius-server timeout <seconds>
Parameters
no
Use the no form of this command to reset the default value.
seconds
Specify the number of seconds to wait before retransmitting a request that previously timed out. Valid values are 1–60. The default is 3.
Examples
The following example sets a 10-second global timeout value.
hostname (config) # radius-server timeout 10
The following example resets the default timeout value (3).
hostname (config) # no radius-server timeout
User role
Admin
Command mode
Config
Supported appliances
This command is supported on the following appliances running the specified releases or later:
Malware Analysis: Before release 6.4. Support for IPv6 addresses was added in Release 8.2.
Central Management System: Before release 6.4. Support for IPv6 addresses was added in Release 8.3.
Email Security — Server: Before release 6.4. Support for IPv6 addresses was added in Release 8.2.
File Protect: Before Release 6.4. Support for IPv6 addresses was added in Release 8.2.
Endpoint Security (HX): Release 2.5
Network Security: Before release 6.4. Support for IPv6 addresses was added in Release 8.2.
Intelligent Virtual Execution - Server: Release 7.9. Support for IPv6 addresses was added in Release 8.2.