Enables or disables a TACACS+ server on the specified port. A TACACS+ server is enabled by default after it is added to the appliance configuration. You can also use the no form of the command to add a TACACS+ server that is initially disabled.
Syntax
[no] tacacs-server host <ip address> auth-port <port number> enable
Parameters
no
Use the no form of this command to disable a TACACS+ server or add a new TACACS+ server that is initially disabled.
ip address
Specify the IPv4 address of the TACACS+ server.
port number
Specify the UDP port number. The default is 49. Valid values are 1–65535.
Example
The following example disables the specified TACACS+ server.
hostname (config) # no tacacs-server host 172.16.1.1 auth-port 490 enable
User role
Admin
Command mode
Config
Supported appliances
This command is supported on the following appliances running the specified releases or later:
Malware Analysis: Before release 6.4.
Central Management System: Before release 6.4.
Email Security — Server: Before release 6.4.
File Protect: Before Release 6.4.
Endpoint Security (HX): Release 2.5
Network Security: Before release 6.4.
Intelligent Virtual Execution - Server: Release 7.9.