Configures the IPv4 address of the default gateway for the live ether1 or ether2 interface.
The appliance uses the live ether1 or ether2 interface if controlled live mode or URL dynamic analysis is enabled.
Syntax
[no] analysis live default-gateway ip <ipAddress>
Parameters
<ipAddress>
IPv4 address of the default gateway for the live ether1 or ether2 interface. If the live ether2 data interface is required, Trellix recommends that you keep the ether2 interface logically separate from the main network traffic so that the ether1 management interface resides on a different subnet from the ether2 interface.
no
Use the no form of the command to clear the default gateway IP address.
Example
The following example specifies that the default gateway for the live ether1 or ether2 interface is at 172.16.1.1:
hostname (config) # analysis live default-gateway ip 172.16.1.1
User role
Admin
Command mode
Config
Supported appliances
This command is supported on the following appliances running the specified releases or later:
Email Security — Server: Release 7.8. Support for the live ether1 interface was added in Release 8.0.
Intelligent Virtual Execution - Server: Release 9.0.0