Shows the configuration of the live ether1 or ether2 data interface and the optional proxy server used to access the Internet.
The appliance uses the live ether1 or ether2 interface if controlled live mode or URL dynamic analysis is enabled.
Important
Validate end-to-end connectivity before you enable controlled live mode or URL dynamic analysis. To perform this validation using the CLI, use the
analysis live check‑connectioncommand in configuration mode.
Syntax
show analysis live config
Parameters
None
Example
The following example shows the configuration of the live ether2 data interface.
hostname # show analysis live config Malware Analysis Mode Enabled : yes Malware Download Timeout : 120 (sec) Malware Analysis VMs : 100 (percent) Live Analysis Configuration Interface : ether2 Default Gateway : 172.16.1.1 External IP : 192.168.0.9/16 Internal IP : 169.254.100.1/24 Name Server : 172.16.2.1 Http Proxy : www.lagado.com:8080 Http Proxy Authentication: root/******** Force Data Interface For Prefetch : no
Important
Controlled live mode and URL dynamic analysis are each disabled by default. You enable each feature separately from configuring their shared feature settings Do not enable either of these features until after the live ether1 or ether2 interface and (if used) proxy server settings are configured.
Output fields
The following table describes the output fields:
Field | Description |
|---|---|
Interface | Name of the live ether1 or ether2 data interface. |
Default Gateway | IPv4 address of the node used by the live ether1 or ether2 interface to access the Internet default gateway. |
External IP | External IPv4 address and mask length of the live ether1 or ether2 data interface. |
Name Server | IPv4 address of the Domain Name System (DNS) name server for the live ether1 or ether2 interface. |
HTTP Proxy | Fully qualified domain name (FQDN) or IPv4 address and port number of the node acting as the HTTP proxy server for the live ether1 or ether2 interface. |
HTTP Proxy Authentication | Username used to authenticate at the proxy server. |
User role
Admin
Command mode
Enable
Supported appliances
This command is supported on the following appliances running the specified releases or later:
Email Security — Server: Release 7.8. Support for the fully qualified domain name was added in Release 7.9. Support for the live ether1 interface was added in Release 8.0.